Our DEEP REACH anvil is perfect for wheeling in confined areas! Also especially helpful for for making small shapes, such as the tight end of a tear drop blister. It's also great for turning an edge.
Makes an otherwise tricky job a snap! It's a great choice for important secondary operations that make the difference between getting that special project 'done' and 'done right'!
Overall size is 2" wide x 3-½" in diameter with a raised 3/4" rad. center section. The shoulder dia. is 1-5/8" to allow maximum clearance. Anvil has pressed-in sealed bearings and a ½" steel axle.
Note: Compatible with Fournier QuickShaper & QuickShaper Mark II
MADE IN USA