Our EDGING anvil is perfect for surface clean up. Use this optional anvil for a professional final finish to remove dents or low spots directly next to an angle that has already been bent.
Makes an otherwise tricky job a snap! It's a great choice for important secondary operations that make the difference between getting that special project 'done' and 'done right'!
Edging anvil has an offset 3/4" wide flat surface with 1/16" rad. corners. Overall size is 2" wide x 3" in diameter with pressed-in sealed bearings and a ½" steel axle.
Note: Compatible with Fournier QuickShaper & QuickShaper Mark II English wheels
MADE IN USA
