Eckold Metal Forming Tools
Eckold tools are available for shrinking, stretching, doming, planishing, flattening, straightening, flanging, notching, punching and edging of sheet metal parts!
Just drill a pilot hole for the draw bolt and then apply the tool and tighten. The finished hole is smooth and has a stengthening bead.
Use in Mittler Bench Presses with spring loaded center pin and just center punch, no drilling needed.
These can also be used as regular hole punches by not using the flare forming ring.
Anti-friction bearings are included with purchase.
AUTOMOTIVE PUNCH & BEAD TOOL KIT OF 6 SIZES INCLUDES:
1"
1-1/4"
1-1/2"
1-3/4"
2"
2-1/2"
MADE IN THE USA
Just drill a pilot hole for the draw bolt and then apply the tool and tighten. The finished hole is smooth and has a stengthening bead.
Use in Mittler Bench Presses with spring loaded center pin and just center punch, no drilling needed. These can also be used as regular hole punches by not using the flare forming ring. Anti-friction bearings are included with purchase.
PUNCH & BEAD TOOL KIT OF 7 SIZES INCLUDES:
1"
1-1/4"
1-1/2"
1-3/4""
2"
2-1/2"
3"
MADE IN THE USA
Just drill a pilot hole for the draw bolt, then apply the tool and tighten the bolt for a smooth, flared hole in one easy step. Punch & Flare tools can also be used as a hole punch, simply by using the punch & die.
PUNCH & FLARE TOOL KIT OF 7 SIZES INCLUDES:
1"
1-1/4"
1-1/2"
1-3/4"
2"
2-1/2"
3"
Anti friction bearings are included.
MADE IN THE USA
View: Optional punch/flare setup using a bench press.
Just drill a pilot hole for the draw bolt, then apply the tool and tighten the bolt for a smooth, flared hole in one easy step. Punch & Flare tools can also be used as a hole punch, simply by using the punch & die.
PUNCH & FLARE TOOL KIT OF 6 SIZES INCLUDES:
1"
1-1/4"
1-1/2"
1-3/4"
2"
2-1/2"
Anti friction bearings are included.
MADE IN THE USA
View: Optional punch/flare setup using a bench press.
MOTORCYCLE METAL FABRICATION: from Sheet to Street
Watch master metal fabricator Ron Fournier create custom motorcycle sheet metal parts from scratch, including construction of an aluminum tank, fairing and front fender in this comprehensive film.
Also featured is step-by-step fabrication of the bike's entire rear section which includes the fender, sides and seat pan. Each step and every technique is clearly demonstrated in a manner that shows the viewer how to make custom parts of their own design.
The entire metal shaping process is detailed with thorough explanations & helpful tips to 'de-mystify' metal working magic. From pattern to finished product - Ron explains custom metal work - the result is professional and ready for paint. Armed with fundamental metal shaping knowledge, some essential tools - and a few "tricks of the trade", you can take your next project from sheet to street!
Demonstration & Instruction on:
Project Planning
Pattern Development
Buck Design & Fabrication
Annealing
Blocking and Smoothing
Metal Shaping using an English wheel
Shrinking & Stretching
Heliarc Tack-Welding & Gas Welding
Tips on Final Trim & Fit
Metal Finishing
Over 3-1/2 hours of metal working instruction in this 2 DVD SET!